Bescor Mp 101 Manual

Maxwell Electronic Power Panner, aka Bescor MP-101 Motorized Pan Head, aka. The head can operate in two panning modes — manually controlled. The Bescor MP-1AC Motorized Pan & Tilt Head Kit includes the MP-101 This head can be powered by four AA batteries, the Bescor PS-260 AC power supply, Bescor mp360 manual meat – Motorized pan/tilt head for the G85 Micro Four Thirds – Re Motorized pan/tilt head for the G85 Micro Four Thirds.

Thats a pretty nifty pan/tilt head. It can move a lot of mass if you balance the load. Here's a link to a picture of a remote controlled camera with a huge zoom lens and infrared lights I made with one. The lights pan and tilt with the lens by the way. The pan/tilt has DC motors and gearing, thats it. No position sensing as far as i could tell.

It does allow variable speed for both the pan and tilt axes. Its remote controllable through that round plug. If you wanted to use one for timelapse, I wouldn't bother taking it apart.

Just put a relay in the common wire on the remote plug. Use the relay to interrupt the movement except for a short pulse after each exposure is completed. If you have a Dynamic Perception MX-2 controller, use it to power the relay from either of the motor outputs. Any 12 volt relay should work as long as the coil draws less than an amp (pretty much any 12VDC relay).

Use the MX-2 in interleaved (shoot, move, shoot) mode. The MX-2 will adjust the duration of the relay-on pulse depending on the inches per exposure you set.

Wire the pan/tilt to the relay contacts that conduct only when the MX-2 wants to move the dolly motor. You can set different speeds for the pan and tilt axes by adjusting the resistance from the common control wire to one or two of the other pins on the remote plug. This way only one motor plug on the MX-2 needs to be used to control two axes on the pan/tilt head and you can move each axis at a different speed if you want.

The remote plug on the pan/tilt has five wires. Common, left, right, up, down. Conductivity between common and one or two of the other pins makes it go. Sat Jul 02, 2011 11:45 am.

Well i ordered one of these, NEW, unfortunatly it arrived yesterday and it was clearly used, and it was a non functioning unit. The Automatic mode worked, but the Manual mode does not, it was worn all around with grime in it. I just spoke to the company that sold it to me through amazon and they are sending me a return label, then will ship me a new one. What a pain in the butt, i really wanted to crack this thing open however they are taking care of it. Mistakes happen. Anyway, my first impression was 'Wow, this thing is small!' It fits on my timelapse Rail Chronos 1.0 nicely.

It just LOOKS like it belongs. The movement on the automatic mode is very smooth, very quiet. The tilt was not working, if it WAS i probably would have kept it, but i did not want to find out that the tilt motor was not working. I opened the front plate, there is a control circuit in there as expected however there are a BUNCH of wires from the control circuit into the housing, i dont think they are all wires for the motors. Being a Bescor 101 i know it has a tab that hits a switch preventing a full 360 degree panning, so the extra wires are probably for that switch.

Upon opening the other side (battery side) thats all it is, batteries, and a pair of wires. So all the mechanical guts fit into the central body of the unit. Ive seen pics of the body opened up exposing a couple worm gears on wevbsites that show the easy conversion from a Bescor MP101 to Mp-360. I am fully confidant ill be able to take control of this thing with a motor driver shield and arduino. Ill be very careful to document my processess, take shots of everything.

This may be about the best timelapse P&T deal on the market for the DIY'ers Another guy has created a very slick system called AUTOMATE 1.0 based off this unit, turning it into a smartphone controlled bluetooth connected timelapse?gigapan head and sells them for 400 bucks. Not a bad deal for all the development he put into it, however, if i went with the AUTOMATE i would just have to hack it to get it to work with my system anyway.

He is the bad guy who is with the bad girl (delfina), but became good when falls in love with the good girl (Florencia). 5) The songs!!! Ley With Malala make a duo really bad but funny too 4) Esteban Prol. Although he is a little bit stereotyped, I just love him. 6) Florencia, Juan Gil Navarro, Fabio Di Tomaso, Benjamin Rojas:), Henny Trailes, etc.

It was released around the time of BDS2006 but installs just fine in BDS2007. Ray 'Loren Szendre' wrote in message news:104881@forums.codegear.com. Quick report for delphi xe2 professional